The Dometic has youtube reviews, but Mabru just has the company reviews on youtube, at least earlier in the summer when I was looking. But, no hard specs- they said they might post something later on in the year.īeyond this exhange, I couldnt find any independent reviews. They had one installed in an unfinished van, and they said it seemed quiet (the dB rating of 33 also seemed low), and the btu output seemed more powerful than the Dometic. I was looking into the Mabru unit also, and was even considering asking the same type of question- Mabru units, too good to be true? So, earlier this summer, I contacted vanlife outfitters to get a comparison of the 12000 btu mabru vs the dometic rtx. We have a big battery bank and inverter, but don't run the rear AC off it as it would still quickly get depleted. ![]() We have a generator and run the rear AC off it if necessary, so a 12V AC is not the ONLY solution. You are going to need a second alternator, which is expensive. None of the alternators for my year are rated to provide 100 Amps to auxiliary equipment. I don't think you can take that from the stock alternator. I don't think you can run this AC off a DC to DC converter. Properly charged, the front AC does reach to the rear, although it isn't great back there. This isn't a good candidate for try it and see how it goes. I'm just suggesting you run all the numbers carefully, or you will wind up with a system that doesn't actually cut it and have to throw more money you didn't expect at it. I have read about some that are doing it this way successfully, with a big second alternator and battery bank, but the whole setup is expensive. Not Included:Īpply For A Wholesale Account w/ Our Sister Company, Upfitters Wholesale.Click to expand.I don't think you can run this AC off a DC to DC converter. **Failure to properly install using Dometic approved installation kit may void the warranty. If you order the RTX unit by itself, (without the above listed Installation Kit) your order will arrive with NO installation hardware or wiring. *The unit by itself only comes with a pigtail wire connector. ![]() (98 mm) must be maintained from other external attachments. ![]() The ventilation openings must not be covered.Mount the unit slightly forward of the vehicles center (front to back) and centered from side to side.This opening must be located between the roof reinforcement beams. When no roof vent is available or when another location is desired, an opening must be cut through the roof and ceiling of the vehicle.The unit is designed to fit over an existing roof vent opening or a new roof opening created by the installer. The joist support frames must be spaced no greater than 16 in.The roof opening is part of the return air system of the unit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |